The metal oxide surge arrester (MOA) is an advanced overvoltage protector in the word. The metal oxide varistors (MOV),Adopt overvoltage limiter Technology . It have good response to steep front surge, excellent volt-ampere characteristics and high discharge capability, which provides a very consistent protection merit at steep front surge, lightning surge and switching surge, and enhances protective capability.
The product has been confirms by the Chinese national center for quality supervision and test of insulators and surge arrest-
ers. The technical performance of the product conforms to IEC60099-4 standard technical requirements.
金屬氧化物避雷器(M O A)是世界上較先進的過電壓限制器,其核心元件——金屬氧化物電阻片(M O V),采用過電壓限制器技術。它具有良好的陡波響應能力、卓越的非線性伏安特性和巨大的通流容量,在尖頂波、操作波和雷電波下均有優異的保護能
力,工作性能幾乎不受波形的影響。
本產品已通過國家絕緣子避雷器質量監督檢驗中心型式試驗,所有參數均嚴格按國際標準IEC 60099-4《交流無間隙金屬氧化物避雷器》執行。
Every polymeric housed MOA puts up the disconnector. The disconnector is equipped with the insulation base. The top bolt of disconnector is directly con- nected with the bottom of MOA, the below bolt is connected with ground lead.
The disconnector shall break away automatically at the fault current while the
MOA failure under the abnormal conditions, and the failed MOA will be separated.
The figure shows the produc’s operation. The dotted line in the figure shows the situation of the grounding part’s disconnection while the disconnector operation.
所有復合外套MOA均可以配套脫離器,其一般安裝于絕緣支架上。上部直接與避雷器的低壓端連接,下部連接接地導線。
當MOA損傷,出現異常電流時,脫離器將自動脫離, 使損傷的MOA退出系統脫離器的工作情況見右圖。圖中虛線表示的就是脫離動作后,接地部分斷開的情形。
Current 電流 (A)
|
800
|
200
|
20
|
5
|
0.5
|
0.95
|
Operation times 動作時間 (s)
|
0.01~0.02
|
0.02~0.05
|
0.1~0.2
|
0.5~1.0
|
20~50
|
200~500
|
Note: The last “ L” in the designation means the disconnector. Such as YH10W-24L means that the diconnector has be equipped in the MOA of YH10W-24. If the disconnector isn’t equipped, the “ L” no appear.
注意:型號最后的字母“L”表示脫離器。例如YH10W-24L,表示在型號為YH10W-24的MOA上安裝了脫離器。若不安裝,將不會有字母“L”。